Products
Aqua Tek Waterproof Headphones for the Deus II
$165.00
Aqua Tek headphones are designed for comfort and fit. 100 '+ Depth Rating Conical speakers for Deep Rich Tones High Quality Minelab approved Connector by Holin MFG. Cords and Wire Made in USA Perfect for Land, Snorkeling and Diving 2 Year Warranty
Aqua-Tek Waterproof Headphones for Equinox
$159.00
Aqua Tek headphones are designed for comfort and fit. 200 '+ Depth Rating Conical speakers for Deep Rich Tones High Quality Minelab approved Connector by Holin MFG. Cords and Wire Made in USA Perfect for Land, Snorkeling and Diving 2 Year Warranty Compatible with VM08 Wireless Module
Aqua-Tek Waterproof Headphones for Garrett AT Series metal detectors
$165.00
Designed for comfort and fit. These headphones are made of the highest quality materials and best of all the are Made in the USA. 200'+ Depth Rating Oversized Speaker Elements for Deep Rich Tone High Quality Minelab Approved Connectors by Holin MFG Cords and Wires are Made in the USA Perfect for Land, Snorkeling & Diving Assembled in the U...
Dan's Laynards, Lanyard (red, orange, slate blue, hunter green, Sea Foam and black) - 36"
Accessory
Dan's Laynards, Lanyard (red, orange, slate blue, hunter green, Sea Foam and black) - 36"
$16.00
Lanyards – extends to 36” High quality hardware + construction Never “misplace” your pinpointer again Connects in seconds Durable design keeps pinpointer visible even if dropped An affordable “insurance policy” for your pinpointer
Detecting Adventure 8" T-Rex Stainless Steel Sand Scoop with 3/8" Honey comb holes
Sand Scoop
Detecting Adventure 8" T-Rex Stainless Steel Sand Scoop with 3/8" Honey comb holes
$239.00
The T-REX bucket is approximately 11” long by 8” wide and 4 7/8” deep. The top of the scoop is 5” deep to prevent targets from being knocked out of the scoop while hunting in the surf. On the top of the scoop is a tube to attach your handle. The Handle tube is angled at about 20 degrees so digging is easier than with a straight up and down ...
Detecting Adventure Shaft Mount Pinpointer Holder
$14.75
Detecting Adventure Shaft Mount Pinpointer HolderThis pinpointer holder will fit standard round detector shafts 7/8” diameter. It is designed to fit Deus, Garrett, and Land or Sea pinpointer. Also, any cylindrical pinpointer which tapers from 3/4” at the tip to 2” at the top.MADE IN THE USA
Detecting Adventures T-Rex Stainless Steel 9.5" With 3/8th Inch Honeycomb Holes
Sand Scoop
Detecting Adventures T-Rex Stainless Steel 9.5" With 3/8th Inch Honeycomb Holes
$259.00
The T-REX bucket is approximately 11” long by 9 1/2” wide and 4 7/8” deep. The top of the scoop is 5” deep to prevent targets from being knocked out of the scoop while hunting in the surf. On the top of the scoop is a tube to attach your handle. The Handle tube is angled at about 20 degrees so digging is easier than with a straight up and down h...
Minelab CTX 3030 Standard Carbon-Fiber Lower Rod by Steve's Detector Rods (32 inches)
Shaft Hardware
Minelab CTX 3030 Standard Carbon-Fiber Lower Rod by Steve's Detector Rods (32 inches)
$89.00
Our lower rods designed for the CTX 3030 are an affordable alternative to the factory lower rods. These rods are the same length and diameter as the original Minelab hardware. However, several improvements have been carefully engineered into them, including the opening for the coil cable being moved to the right-hand side of the rod in our desig...
Minelab Equinox 600/800 Coil Ear Replacement
$29.99
If your coil is out of warranty and you do not want to spend $200+ dollars on a new coil we have the answer. We have designed the Coil Ear Replacement for the Equinox 600/800. Just sand down the broken coil ears to the coil surface. Scuff surfaces to allow the Epoxy to grip. Add a generous amount of 2 stage Marine Epoxy. Secure with 2 zip ties a...
Shelling bags. Reinforced nylon. Available in three unique design. 12"X13”
$24.95
Beautiful design, made in the USA with reinforced construction, this premiere shelling bag has two pockets, large mesh for instant draining, and front pocket for valuables. High quality construction, made to last.
Steve's Detector Rod for Minelab Equinox 600/800 Complete Black Carbon-Fiber Shaft System with End Cap
Shaft Hardware
Steve's Detector Rod for Minelab Equinox 600/800 Complete Black Carbon-Fiber Shaft System with End Cap
$129.00
BRAND NEW!!!Our "standard" complete shaft for the Minelab Equinox includes one standard-length (26") lower rod (with spring button, for compatibility with the Minelab stock shaft), along with our standard upper shaft. The upper shaft includes 4 cuff-adjustment holes, and one hole for the control-box handle (in the same positions as the stock Min...
Steve's Detector Rods Minelab Equinox 600/800 Black Carbon-Fiber Lower Shaft
Shaft Hardware
Steve's Detector Rods Minelab Equinox 600/800 Black Carbon-Fiber Lower Shaft
$77.99
BRAND NEW!!!Our lower rods for the Minelab Equinox are slightly longer than the factory rods, but with the spring button clip located at the same position (22 3/4" from the end of the rod) as on the factory rod. This design allows a slightly longer section of the lower rod to remain inserted in the middle rod, as compared to the factory rod, w...
T-Rex 6.5" Stainless Steel with 3/8" Honey Comb Holes by Detecting Adventure
Sand Scoop
T-Rex 6.5" Stainless Steel with 3/8" Honey Comb Holes by Detecting Adventure
$219.00
The T-REX bucket is approximately 11” long by 6.5" wide and 4" deep. The top of the scoop is 5” deep to prevent targets from being knocked out of the scoop while hunting in the surf. This scoop has 1/4" round holes 2" from the back and bottom of the scoop to catch small items. On the top of the scoop is a tube to attach your handle. The Handl...